Makita GA4030R Manuel D'instructions page 11

When installing the diamond wheel:
Fig.16: 1. 2. Diamond wheel (Thinner
Operation with wire cup brush
Optional accessory
CAUTION:
Check operation of brush by run-
ning tool with no load, insuring that no one is in
front of or in line with brush.
CAUTION:
Do not use brush that is damaged,
or which is out of balance.
Fig.17: 1.
access to spindle.
NOTICE:
Avoid applying too much pressure
which causes over bending of wires when using
brush.
Operation with wire wheel brush
Optional accessory
CAUTION:
Check operation of wire wheel
brush by running tool with no load, insuring that
no one is in front of or in line with the wire wheel
brush.
CAUTION:
Do not use wire wheel brush that
is damaged, or which is out of balance. Use of
CAUTION:
ALWAYS use guard with wire
inside guard.
OPTIONAL ACCESSORIES
CAUTION:
These accessories or attachments are recommended for use with your Makita tool spec-
Fig.20
-
1
2
4
5
6
3. Diamond wheel (4mm
4.
11 ENGLISH
Fig.18: 1.
access to spindle.
NOTICE:
Avoid applying too much pressure
which causes over bending of wires when
using wire wheel brush.
MAINTENANCE
CAUTION:
Always be sure that the tool is
switched off and unplugged before attempting to
perform inspection or maintenance.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
Air vent cleaning
Fig.19: 1. 2. Inhalation vent