Swarovski Optik CTS 85 Mode D'emploi page 7

operation
remove the objective and ocular lens cap
The lens and eyepiece are
protected against dirt and
damage by caps.
The caps can be pushed
to the side (without ope-
ning the press studs) when
making observations.
Alternatively, you can open one of the press studs,
move the caps to the side of the body and then
close the press stud again.
remove the protective cover for
the bayonet from the bayonet lock
To fit the eyepiece, pull out
the extendable tube.
To remove the cover, slide
the locking mechanism of
the
and turn the protective
cover to the left (anti-clockwise).
attachment of the eyepiece
• Remove the protective
cap for the bayonet from
the eyepiece by screwing it
to the left (anti-clockwise).
DE EN
eyepiece downward
12
• The protective cap for the
eyepiece is attached to the
2
eyepiece with a cord. By
1
loosening the screw on the
eyepiece with a screwdri-
ver, you can remove the
cord with the cap from the eyepiece. Please rein-
sert the screw.
• Align the marking on the
eyepiece with the marking
on the bayonet fitting.
• Insert the eyepiece and
turn it to the right (clock-
wise)
mechanism of the body clicks into the eyepiece.
Detachment of the eyepiece
To remove the eyepiece,
press the locking mecha-
nism of the body down-
ward and turn the eyepiece
to the left (anti-clockwise)
until it can be removed.
Extend for use
Hold the body and the ocu-
lar of the extendable spot-
ting scope firmly.
EN DE
until the locking
13