V-ZUG AdorinaSéchage V400 AT4HWW Série Mode D'emploi page 117

Troubleshooting
End/Anti-creasing symbol is on.
• Crease Guard programme is activated in order to prevent laundry that has remained in the machine from
creasing. >>> Turn off the dryer and take out the laundry.
End symbol is on.
• Programme is over. Turn off the dryer and take out the laundry.
Lint Filter Cleaning symbol is on.
• Lint filter is not cleaned. >>> Clean the lint filter.
Lint Filter Cleaning symbol is flashing.
• Filter housing is clogged with lints. >>> Clean the lint filter housing.
A deposit has built up on the lint filter pores that may cause clogging. >>> Wash the lint filter with
•
warm water.
• Filter drawer is clogged. >>> Clean the sponge and the filter cloth in the filter drawer.
Water leaks from the loading door
• Lint has accumulated on the inner surfaces of the loading door and on the surfaces of the loading door
gasket. >>> Clean the inner surfaces of the loading door and the surfaces of the loading
door gasket.
Loading door opens spontaneously.
• The machine is overloaded. >>> Reduce the amount of laundry and restart the programme by
pressing the Start/Pause button.
Condensate Tank warning symbol is on/flashing.
• Condensate tank is full. >>> Drain the condensate tank.
• Water draining hose is bent. >>> If the product is connected directly to a wastewater drain, check the water
drain hose.
Filter Drawer Cleaning warning symbol is flashing.
Filter drawer is not cleaned. >>> Clean the sponge and the filter cloth in the filter drawer.
•
The condensate tank and filter drawer cleaning symbols are on.
• In the case of very low load or synthetic laundry, the appliance may not be able to measure the humidity of the
laundry. >>> Use the additional programme «Timed drying» or increase the load.
Dryer / User Manual
117 / 120 EN