Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
5
Maintenance and cleaning
Service life of product extends and frequently
experienced problems will be reduced if it is cleaned at
regular intervals.
5.1 Cleaning Lint Filter / Loading Door
Inner Surface
Lint and fiber released from the laundry to the air during
the drying cycle are collected in the Lint Filter.
C
Such fiber and lint are generally formed
during wearing and washing.
A
Always clean the lint filter and the inner
surfaces of the loading door after each
drying process.
C
You can clean the lint filter housing with a
vacuum cleaner.
To clean the lint filter:
•
Open the loading door.
•
Remove the lint filter by pulling it up and open the
lint filter.
•
Clean lint, fiber, and cotton raveling by hand or with
a soft piece of cloth.
•
Close the lint filter and place it back into its
housing.
•
A layer can build up on the filter pores that can
cause clogging of the filter after using the dryer
for a while. Wash the lint filter with warm water
to remove the layer that builds up on the lint
filter surface. Dry the lint filter completely before
reinstalling it.
112 / 120 EN
•
Clean the entire inner surface of the loading door
and loading door gasket with a soft damp cloth.
5.2 Cleaning the sensor
There are dampness sensors in the dryer that detect
whether the laundry is dry or not.
To clean the sensors:
•
Open the loading door of the dryer.
•
Allow the machine to cool down if it is still hot due
to the drying process.
•
Wipe the metal surfaces of the sensor with a soft
cloth, dampened with vinegar and dry them.
C
Clean metal surfaces of the sensors 4
times a year.
C
Do not use metal tools when cleaning
metal surfaces of the sensors.
Dryer / User Manual
Publicité
Table des Matières
