Paring The Indoor Unit / Outdoor Unit; Location - Alecto WS-3400 Guide De L'utilisateur

Indoor unit:
Slide the battery cover at the rear downwards, insert 2 AA 1.5V batteries as indicat-
ed inside the battery compartment and replace the battery cover on the indoor unit.
(Batteries are not included)
The indoor unit now starts searching for the outdoor unit for 1 minute. Insert the
batteries into the outdoor unit within this minute.
Outdoor unit:
Open the battery compartment by loosening the top of the outdoor unit. Open the battery compartment by
removing the cover. Insert 3 AA 1.5V batteries according to the image above. Pay attention to the polarity (+
and -) while doing so. Replace the cover and secure the top back onto the base (batteries are not included).
Mount the sensor onto a pole (28~40 mm) using the clips with the large screws and bolts.
Preferably, install the outdoor unit at least 1.5m above ground level in an open space within the transmitting
range of the outdoor unit to the indoor unit, making sure it can freely catch the wind.
Remarks:
• After replacing the batteries of the outdoor unit or after an interruption of the connection with the outdoor
unit, press the "SCAN" button on the indoor unit to reconnect the outdoor and indoor unit.
• Avoid placing the unit in direct sunlight, rain or snow.
• Try multiple locations to obtain the best possible reception between the outdoor unit (transmitter) and
indoor unit (receiver).

3.2 Paring the indoor unit / outdoor unit:

Automatically:
As soon as the batteries are inserted into the indoor unit, the indoor unit starts searching a signal from the
outdoor unit for 1 minute. So, when you insert batteries into the outdoor unit within this minute and the units
'find' each other, these units will be paired automatically. The display of the indoor unit shows the tempera-
ture, humidity and wind speed as transmitted by the outdoor unit.
Manually:
If the units cannot automatically find each other, or after replacing the batteries, you may pair the outdoor
unit with the indoor unit (again) as follows:
1. Press and hold the SCAN button for 2 seconds, the antenna symbol
2. Or alternatively briefly press the RESET button at the bottom of the outdoor unit
3. After several seconds the units will find each other (again)

3.3 Location:

Indoor unit:
You may choose to suspend the indoor unit from a wall with a simple screw or to use
it as a desk model with the supplied stand. In any case, never place the indoor unit in
direct sunlight or next to a heat generating light or stove.
Outdoor unit:
You may install the outdoor unit on a pole (excluded). In any case, make
sure to place the unit preferably 1.5 metres above ground level where it
can freely catch the wind.
48
Not
included
in the display starts flashing
reset
AA 1,5V
AA 1,5V
AA 1,5V