Installation Instructions - Procopi JetVac Manuel D'installation Et D'utilisation

Installation instructions

1
Install the wall fitting
Installs in minutes on pools with a dedicated vacuum point equipped with a tapped 1"1/2 union .
1. Separate the wall fitting from the quick disconnect and screw the wall fitting into the vacuum point.
2. Insert the quick disconnect into the wall fitting making a1/4 clockwise turn. Pull on the quick disconnect to
secure it in position.
Quick disconnect
with relief pressure
valve
2
Adjust the length of the feed hose
1. Take the feed hose out of its packaging and stretch it out beside the pool (in the sun if possible).
2. Using a telescopic handle, measure the water depth at the deepest point (figure 1).
Cut the feed hose (A) so that its length corresponds to this depth (example, the feed hose originally
measures 3 m, if the max pool depth is 2.40 m, cut off 0.60 m).
3. Connect the feed hose to the wall fitting with the quick disconnect and pull the free end gently to the
furthest point in the pool (figure 2), be careful not to pull too hard. Measure the length of the hose that
extends beyond the pool wall at this point. This is the superfluous length. If the furthest point is at a step,
measure the length at the point level with the second tread.
Disconnect the swivelling union (D) between the two hose sections (B and C), and cut a portion equal
to half the superfluous length from each section. (example, the superfluous length is 50 cm, cut
25 cm from each of the hose sections (B and C). There should be a float on each hose section, floats
should be positioned at regular intervals.
Figure 1
2.40 m
Wall fitting
Strainer
11/16 2011/06 - Indice de révision : C - Code : 0030050
to vacuum point