Procopi JetVac Manuel D'installation Et D'utilisation page 10

Introduction
Congratulations on your purchase of a JetVac automatic cleaner! Thank-you for placing your trust in our product.
Tried and tested, JetVac will provide you with years of trouble-free service.
However, like all mechanical devices, it will require regular inspections and maintenance. Before using your JetVac for
the first time, turn the wheels about twenty times. After winterizing your pool, clean it manually to remove debris (sand,
stones, leaves, etc.) before putting JetVac to work.
After prolonged use, wear parts will need to be replaced. We strongly recommend that you have your JetVac checked
over by your local dealer.
Only use JetVac original parts. Other parts may not comply with JetVac specifications and could cause the cleaner to
malfunction or could even damage it.
JetVac should be installed by a professional. The installation instructions provided in this booklet are intended for
persons qualified to install mechanical equipment and carry out plumbing.
The JetVac cleaner is designed to be driven by a pressurised jet of water generated by a booster pump (not included)
connected to a dedicated vacuum fitting.
For JetVac to operate correctly, a booster pump with a power rating between 0.75 and 1.20 kW is recommended. The
booster pump must be connected to a control panel and installed in accordance with the standard NF C 15-100.
1
2
3
4
1. Filtration bag
2. Balancing float
3. Sweep hose
4. Sweep hose cleaning brush
5. Cleaner body
6. Feed hose
7. Hose float
8. Quick fit connector with wall fitting
5
10/16
7
6
2011/06 - Indice de révision : C - Code : 0030050
8