Commissioning - Zehnder 0-10V67 Manuel De L'utilisateur

6

Commissioning

Press and hold the selection key for
5 seconds to confirm a selected mode.
If the selection key is not pressed for
30 seconds while no mode is confirmed,
the unit returns to the normal operating
mode. No changes are saved.
The CO sensor
2
possibility of setting the output signal as a
sensor or controller signal.
If the control unit is set to sensor mode it
will function as a standard CO2 sensor. If
the control unit is set to controller mode
then it can also be used as a manual speed
controller.
The 0-10V function must be set before use:
1. Press the operating button for 5
seconds.
- All the indicators flash green 3x.
- The middle indicator in the right
column flashes red.
2. Press the operating button within 30
seconds and hold it for 5 seconds.
- The bottom and middle indicators in
the right column flash red.
3. Press the operating button briefly within
30 seconds to select the correct mode.
a. 0x or 2x: controller mode (CO
indicator green, bottom 2 indicators
right column red);
b. 1x: sensor mode (CO
bottom 2 indicators right column red);
4. Press the operating button for 5
seconds to confirm the selection.
- All the indicators flash 3x.
10 - EN
0-10V67 offers the
2
indicator red,
2