Firex PM.G A Serie Manuel D'installation, D'entretien Et D'emploi page 45

3.2.3. SWITCH ON, START OF COOKING AND SWITCH OFF
The appliance is equipped with a selector to start all cooking operations (see figure "Cotrols").
−
Here is a list of the procedures for a safe and correct use of the appliance.
−
Lighting the pilot burner:
Open the gas cock before the appliance.
−
Turn the knob from position " " leftwards to the position " ", press the knob and together press the
−
piezoelectric ignition button repeatedly..
Once the pilot flame is on, keep the knob pressed for a few seconds until the thermocouple heats up.
−
Starting cooking – igniting main burner:
Turn the knob leftwards to the position "
−
Generally cooking is started by setting the knob on the maximum heating position and once the vat has
−
reached cooking temperature, the knob is turned to the minimum position to maintain the cooking
temperature.
End of cooking – turning off main burner and pilot burner:
Turn the knob rightwards until position " " to turn off the main burner; only the pilot flame will be
−
lighted. Turn the knob again until position " " to turn off the pilot burner. (See also figure "Controls").
Do not use aggressive substances or abrasive detergents when cleaning the stainless steel
−
components.
Avoid using metal pads of the steel parts as they may cause rust. For the same reason avoid contact
−
with materials containing iron.
Do not use sandpaper or abrasive paper for cleaning; in special cases use a powder pumice stone.
−
In case of particularly resistant dirt, it is advisable to use abrasive sponges (e.g. Scotch-Brite).
−
It is advisable to clean the appliance only once it has cooled down.
−
Warning! : When cleaning the appliance never use direct jets of water to prevent infiltration of the
liquid and damage to components.
Clean the cooking vat with water and a detergent, rinse thoroughly and dry well with a soft cloth.
−
External surfaces should be washed down using a sponge, and hot water with a suitable proprietary
−
cleaner addend.
Rinse always thoroughly and dry with a soft cloth.
−
Note for pressure kettles:
Do not use detergents containing high percentages of ammonia and sodium to clean the lid gasket, as
−
these substances may cause damage and quickly affect the tightness of the gasket.
Instruction manual for installation, maintenance and use
Gas Kettles PM.G...A
"or until minimum position "
3.3. CLEANING AND CARE OF THE APPLIANCE
3.3.1. DAILY CLEANING
" to light the burner.
- GB - 17 di 28
Page