Photonic LED lumiere annulaire 66/40 Mode D'emploi page 5

Cleaning
Disconnect unit from the mains power supply before cleaning and only clean
with a damp cloth. Never use combustible or flammable liquids. If fluids acci-
dentally enter the device, unplug the mains cable and let the unit dry thoroughly
before using again.
Spare parts
Use only original spare parts. If this is not done, it can lead to personal injury
and material damage.
Responsibility
As the ultimate legal entity, the operating institution is responsible for ensuring
the proper use of the device and for providing other operators with the necessary
information and it specifies the competencies required to operate the device.
DISCONNECT THE MAINS CABLE when the unit is not being used for an extended
period of time.
ONLY USE THE ORIGINAL MAINS CABLE. Route cable so that it cannot be jammed
or severed.
FOR REASONS OF SAFETY only use the grounded 3-pin plug.
Repairs which are not described in this document must only be carried out by
authorized workshops!
The manufacturer is not liable for any damage resulting from a failure to comply
with the above instructions!
Current technology
These LED illumination devices constitute state-of-the-art technology and
employ recognized safety standards.
This instrument was designed and built in accordance with the following
regulations and standards:
EEC/89/336: Electromagnetic compatibility (CE)
ISO 9001/2: Quality systems for development and production
INSTALLATION AND CONNECTION
Remove the individual system components from their packaging and place them
onto a horizontal surface.
To obtain optimal functionality, the LED illumination system must be positioned
correctly.
Observe the following criteria:
No high atmospheric humidity (cf. Technical data)
No high room temperature (cf. Technical data)
The device may only be operated at the rated mains voltage. Only con-
nect the unit to grounded sockets.
Keep air vents free!
The control unit must only be operated with the power-supply provided!
Supply controller with attached power supply. If necessary, use the ESD connec-
tor (10) for potential equalisation.
Plug the LED lighting into the control unit. Only use Port A of the
con trol unit for the LED ringlight 66/40 (and all future products with 40
LEDs). LED spot, backlight and ringlight 38/20 (and all future products with 20
LEDs) can be used on Port A and B. The total number of LEDs connected on port
A and B must not exceed the maximum allowed LEDs (ref. technical data)!
The LED ringlight can now be mounted directly onto the objective of all micro-
scopes with 66 mm diameter by means of a clamping ring which does not
damage the surface of the objective. For objectives with any other diameter
there is a wide range of adapters available.
For mounting the LED spot, spotholder (6) of different lengths and threads are
available, allowing the LED spot to be pointed in any desired direction.
The one end (with the O-ring) of the spotholder is inserted into the opening of
the LED spot. The other end can be screwed directly onto the microscope or
optionally into a base plate.