Photonic LED lumiere annulaire 66/40 Mode D'emploi page 4

DESCRIPTION
This new type of LED illumination device (Light Emitting Diode) has been
developed for stereomicroscopy illumination purposes in industrial and labor-
atory settings.
In purchasing this product, you have acquired a high-quality LED illumination
unit for all applications requiring intensive light with minimal heat generation.
LEDs are employed as the illuminant.
SAFETY INFORMATION
Two danger symbols are used throughout this document.
Caution: Risk of electrical shock
Caution: Dangerous area.
Warning: Refer to accompanying documentation.
This section contains safety information which must be observed
strictly when using this device.
IT IS IN YOUR OWN INTERESTS TO PAY ATTENTION TO ALL WARNINGS on the
unit and in this manual.
Target audience
People working with the device must read the sections which are relevant to
their work. This applies especially to the chapter entitled "Safety information".
Duty of observation with respect to product
The operator must report all operational irregularities or changes to componen-
ts which are relevant to device safety immediately to the responsible supervisor
or the manufacturer.
Location of operating instructions
We recommend storing these operating instructions near the device to ensure
quick access by operating staff.
Legal provisions
National and local safety and accident prevention regulations which are in force
must be strictly observed in addition to the operational guidelines issued by the
operating entity.
Do not make any technical modifications to the device under
any circumstances!
Refer to specifications in "Technical Data" section for binding operational
limits.
DO NOT USE this unit near water or in any area with excessive moisture.
WARNING: In order to prevent electric shock, do not expose this appliance to
rain or high humidity.
NEVER SPILL LIQUID ON THE UNIT OR INSERT OBJECTS INTO THE UNIT! This
could result in electric shock or damage to the unit.
DO NOT PLACE FLAMMABLE MATERIALS on or near the unit at any time. Keep
unit AWAY from other sources of HEAT. The device has not been approved for
operation in areas subject to explosion hazards!
The device may only be operated using the mains voltage indicated.
NEVER OPEN THE APPLIANCE OR ANY COMPONENTS, unless instructed
expressly to do so by these instructions.
Never look directly at the LEDs when switched-on, otherwise you risk
eye injuries.
In accordance with the EN 60825-1 these LED illuminations are classified as
products of laser class 2.