Installing Or Removing Battery Pack; Safety Instructions For Charger And Batteries - Lincoln PowerLuber B 1200 Manuel

Red and Green Lights Alternate Flashing
When battery voltage is below 9 VDC the battery will
be evaluated. This can last up to 5 minutes.
Red Light Flashes
Replace Battery pack

SAFETY INSTRUCTIONS FOR CHARGER AND BATTERIES

This manual contains important safety and operating
instruction for Lincoln Model 1210 or 1210E Battery
Charger.
1. Before using a battery charger, read all instructions
and cautionary markings on Battery Charger, Bat-
tery Pack, and product using battery.
2. CAUTION: To reduce the risk of injury, Lincoln
Model 1210 or 1210E Chargers should only be
used to charge Lincoln battery pack Model 1201.
Other types of batteries may burst causing per-
sonal injury and damage. Do not charge Lincoln
Model 1201 Battery Packs with any other charger.
4. Do not abuse cord. Never carry charger by cord or
yank it to disconnect from receptacle. Pull by plug
rather than cord when disconnecting charger. Have
damaged or worn power cord and strain reliever
replaced
immediately. DO NOT ATTEMPT TO REPAIR
POWER CORD.
5. Make sure cord is located so that it will not be
stepped on, tripped over, or otherwise subjected to
damage or stress.
A
good electrical condition.
B
ing chart:
LENGTH OF CORD IN FEET (M) 25 (7.5) 50 (15) 100 (30) 150 (45)
AWG SIZE OF CORD (mm²)
C
type
acceptable for outdoor use.
7. Do not operate charger with damaged cord or
plug. Have them replaced immediately, to avoid a
hazard DO NOT ATTEMPT TO REPAIR POWER
CORD.
8. Do not operate charger if it has received a sharp
blow, been dropped, or otherwise damaged in any
9. Do not disassemble charger or battery pack. Take
Form 422014
www.treboux.ch info@treboux.ch
SAVE THESE INSTRUCTIONS
-
18 (1) 18 (1) 18 (1) 16 (1.5)
+41 (0)33 221 98 44
INSTALLING OR REMOVING BATTERY
PACK
TO REMOVE BATTERY PACK: Depress the two
battery release buttons (one button on each side of
battery pack) and pull battery pack out of Power-
Luber.
TO INSTALL BATTERY PACK:
pack with opening in PowerLuber handle and push
battery pack into handle until it locks in place.
10. Unplug charger from outlet before attempting any
maintenance or cleaning to reduce risk of electric
shock.
11. Charge the battery pack in a well ventilated place,
do not cover the charger and battery with a cloth,
etc., while charging.
12. Do not store the charger or battery packs in loca-
tions
(such as a metal tool shed, or a car in the sum-
122° F
(50° C) , which can lead to deterioration of the
storage battery.
13. Do not charge battery pack when the temperature
is BELOW 32° F (0° C)or ABOVE 104° F (40° C).
This is very important for proper operation.
15. Do not charge battery in damp or wet locations.
16. Do not attempt to charge any other cordless tool
or battery pack with the Lincoln Model 1210 or
1210E charger.
17. Do not short across the terminals of the battery
pack. EXTREMELY HIGH TEMPERATURES
COULD CAUSE PERSONAL INJURY OR FIRE.
coln Model 1201 Battery Pack contains recharge-
able, nickel-cadmium batteries. These batteries
must be recycled or disposed of properly. Drop off
battery retailer, or your recycling center.
Users in the United States NOTE:
Applicable fees for the collection and recycling of
these batteries have been paid to the RBRCTM.
For further information, call 1-800-8BATTERY.
1210 or 1210E
Battery Charger
Figure 2
Align battery
-
1201
Battery
Page Number - 5