Bio Green PALMA 2.0 Instructions D'installation Et D'utilisation page 24

Palma 2.0 Bedienungsanleitung / Operating Instructions / Bruksanvisningen
3. Installation
Warning! Do not leave the packaging materials (plastic bags, polystyrene, nails etc.) within
reach of children as they represent potential hazards.
Warning! Electrical devices may only be operated in wet rooms connected to a residual
current circuit breaker.
Warning! Before initial operation of the device please ensure that this connection is provided
at the planned connection location.
Warning! The installation location must be selected so that the devices cannot be sprayed
with water or fall into water in any event.
Please note! Lay the connection cables in such a way that nobody can trip over them and
they cannot be crushed or come into contact with hot objects.
Please note! Only use extension cables that are compatible with the output and in
accordance with the valid safety regulations for the device.
Please note! Make sure that the devices are disconnected from the mains power before and
during installation.
When using the Palma 2.0 heater you have the choice of operation with or without the included
wet room thermostat Thermo 2. However for exact temperature regulation and energy-saving
operation we urgently recommend using the Thermo 2.
To install the Palma 2.0, go to section 3.1.
To install the Palma 2.0 RAW, go to section 3.2.
24