General Installation Information; Electrical; Available Pump Head For Central Heating - UTICA BOILERS MAC-150 Manuel D'installation, D'utilisation Et D'entretien

2.5

GENERAL INSTALLATION INFORMATION

Utica Boiler MAC-150 & MAH-125
Dimensions
Gas Connection
Primary Water Content
Air Vent Diameter
Flue Vent Diameter
Utica Boiler MAC-150 & MAH-125
Minimum Clearances for Servicing
Flue Terminal Size Concentric System
Flue Terminal Size 2-Pipe Flue System
Flue Terminal Protruding
2.6

ELECTRICAL

Supply
Power Consumption – MAH-125
Power Consumption - MAC-150
Internal Fuse
Electrode Spark Gap
2.7

AVAILABLE PUMP HEAD FOR CENTRAL HEATING

This is a high static head pump fit for installation on any type of single or double-pipe heating systems. The automatic air
valve incorporated in the pump allows quick venting of the heating system.
NOTICE
The intended use of this pump is a boiler loop. Do not use as a primary system pump.
Q
WATER FLOW RATE
H HEAD
Height
Width
Depth
Top
Bottom
Sides
Front
120 V - 60 Hz
133 W
142 W
F 3.15 A
1/8" to 3/16" 13.5 to 4.5 mm
MIN
Minimum speed of modulation
MAX Maximum speed of modulation
8.66 in / 220.00 mm
9.84 in / 250.00 mm
1.77 in / 45.00 mm
17.71 in / 450.00 mm
3.93 in / 100.00 mm
3.14 in /80.00 mm
4.52 in / 115.00 mm
8
30.04 in / 763.00 mm
17.71 in / 450.00 mm
13.58 in / 345.00 mm
3/4"
0.95 gal / 3.60 l
3.93 in / 100.00 mm
2.36 in / 60.00 mm
HR
240011317, Rev. F [03/31/2017]