Table Des Matières; Before Use - JVC KD-R841BT Manuel D'instructions

CONTENTS
BEFORE USE
BASICS
GETTING STARTED
RADIO
AUX
CD / USB / iPod
ILLUMINATION
(KD-R841BT only)
BLUETOOTH®
AUDIO SETTINGS
MORE INFORMATION
TROUBLESHOOTING
SPECIFICATIONS
INSTALLATION / CONNECTION
How to read this manual
• Operations explained mainly using buttons
on the faceplate of KD-R741BT.
• [XX] indicates the selected items.
• (➜ XX) indicates references are available on
the stated page number.

BEFORE USE

2
Warning
Do not operate any function that takes your attention away from safe driving.
3
Caution
4
Volume setting:
• Adjust the volume so that you can hear sounds outside the car to prevent accident.
5
• Lower the volume before playing digital sources to avoid damaging the speakers by the sudden increase of
the output level.
6
General:
• Avoid using the USB device or iPod/iPhone if it might hinder driving safety.
7
• Make sure all important data has been backed up. We shall bear no responsibility for any loss of recorded data.
• Never put or leave any metallic objects (such as coins or metal tools) inside the unit, to prevent a short circuit.
8 • If a disc error occurs due to condensation on the laser lens, eject the disc and wait for the moisture to evaporate.
• USB rating is indicated on the main unit. To view, detach the faceplate. (KD-R741BT only)
Remote control (RM-RK52):
9
• Do not leave the remote control in hot places such as on the dashboard.
• The Lithium battery is in danger of explosion if replaced incorrectly. Replace it only with the same or
14
equivalent type.
• The battery pack or batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
15
• Keep battery out of reach of children and in original package until ready to use. Dispose of used batteries
promptly. If swallowed, contact a physician immediately.
16
17
Maintenance
18 Cleaning the unit: Wipe off dirt on the faceplate with a dry silicon or soft cloth.
Cleaning the connector: Detach the faceplate and clean the connector with a
cotton swab gently, being careful not to damage the connector.
Handling discs:
• Do not touch the recording surface of the disc.
• Do not stick tape etc. on the disc, or use a disc with tape stuck on it.
• Do not use any accessories for the disc.
• Clean from the center of the disc and move outward.
• Clean the disc with a dry silicon or soft cloth. Do not use any solvents.
• When removing discs from this unit, pull them out horizontally.
• Remove burrs from the center hole and disc edge before inserting a disc.
Connector (on the reverse
side of the faceplate)
2