Télécharger Imprimer la page

Installation - AquaScape Ultra 400 Instructions

Masquer les pouces Voir aussi pour Ultra 400:

Publicité

Les langues disponibles

Les langues disponibles

Installation

• Always operate the pump fully submerged. Failure to do so
will overheat the pump and cause it to fail, thus voiding the
warranty. DO NOT OPERATE DRY!
• Use only in fully-assembled state, paying particular
attention to be sure that both the fi lter screen and sponge
are attached to the pump. Failure to operate the pump
without the fi lter screen or pre-fi lter sponge will allow large
debris to enter the pump, causing the pump to fail and
voiding the warranty.
• Do not wear loose clothing that may become entangled
in the impeller or other moving parts.
• Keep clear of suction and discharge openings.
DO NOT insert fi ngers into pump with power connected.
• Do not pump hazardous materials or liquids other than
water, such as oil or organic solvents.
• Do not block or restrict discharge.
• Products returned must be cleaned, sanitized or
Model Number
Item Number
Maximum Flow Rate
Maximum Head Height
Motor Type
Wattage
Amperage
Power Cord Length
Discharge Hose Diameter
Warranty
Typical Installation in a Decorative Fountain or Pond
• The Ultra
Water Pump is designed to be submerged directly into a decorative fountain basin or pond. Several features and
benefi ts of this pump make it the ideal choice for a wide variety of water feature applications.
ump w AquaBasin Application
Decorative Fountain
4
400
550
#91005
#91006
370 GPH
528 GPH
7.5 ft
8 ft
Mag-Drive
Mag-Drive
24
33
.40
.55
12 ft
12 ft
½", ¾", 1", 1¼"
½", ¾", 1", 1¼"
3-Year Limited
3-Year Limited
decontaminated, as necessary, prior to shipment to ensure
that employees will not be exposed to health hazards in
handling said material. All applicable laws and regulations
shall apply.
IMPORTANT: Aquascape, Inc. is not responsible
for losses, injury, or death resulting from a failure
to observe these safety precautions, misuse or
abuse of pumps or equipment.
Ultra
Water Pump Specifi cations
• Input Voltage: 120V AC
• Input Frequency: 60 Hz
• Submersible pump
• For outdoor or indoor use
• Thermally protected
• This pump has been evaluated for use with water only
• Input Amps & Wattage: See chart below
Ultra
Water Pump Specs
800
#91007
#91008
793 GPH
1110 GPH
9 ft
Mag-Drive
Mag-Drive
58
.80
25 ft
½", ¾", 1", 1¼"
¾", 1", 1¼",1½"
3-Year Limited
3-Year Limited
Pond with external filter
• To maximize pond circulation, locate the pump as far
away as possible from the location of the water entering
back into the water feature.
• It is recommended that the pump NOT be positioned in
the deepest area of the pond. This will protect the fi sh
by preventing the pond from completely draining in the
case of a leak in the plumbing or fi lter. If needed, bricks or
stones can be used to raise the pump off the bottom of
the pond.
US 1-866-877-6637 |
1100
1500
#91009
1480 GPH
12 ft
16.5 ft
Mag-Drive
92
153
.85
1.46
25 ft
25 ft
¾", 1", 1¼", 1½"
3-Year Limited
Shown with Pond Filter Urn (#77006 or #77011)
CAN 1-866-766-3426 | aquascapeinc.com
2000
#91010
1982 GPH
20 ft
Mag-Drive
250
2.60
25 ft
¾", 1", 1¼", 1½"
3-Year Limited

Publicité

loading

Ce manuel est également adapté pour:

Ultra 550Ultra 800Ultra 1100Ultra 1500Ultra 2000