DWT OF-1050 NV Notice Originale page 30

• Perform the milling operation by pressing guide bush-
ing 24 to the side surface of the template (see fig. 22).
Note: the
not be less than 8 mm. Additionally,
when making a template, please note
that the router bit follows the template
contour with a certain offset (distance "b" in fig-
ure 22).
Power tool maintenance /
preventive measures
Before carrying out any works on the power tool it
must be disconnected from the mains.
Cleaning the dust
fig. 23-24)
• Unscrew screws 32 and remove cover 33 as shown
in figures 23-24.
• Clean the groove with a soft brush�
• Install cover 33 and screw in screws 32�
Cleaning of the power tool
An indispensable condition for a safe long-term exploi-
tation of the power tool is to keep it clean� Regularly
flush the power tool with compressed air thought the
ventilation slots 6�
The manufacturer reserves the possibility to introduce changes.
template thickness
extraction groove
After-sales service and application service
Our after-sales service responds to your questions
concerning maintenance and repair of your product as
must
well as spare parts� Information about service centers,
parts diagrams and information about spare parts can
also be found under: www.dwt-pt.com�
• Categorically not to drop any mechanical impact on
the packaging during transport�
• When unloading / loading is not allowed to use any
kind of technology that works on the principle of clamp-
ing packaging�
(see
Recycle raw materials instead of dispos-
ing as waste.
Power tool, accessories and packaging
should be sorted for environment-friendly
recycling�
The plastic components are labelled for categorized
recycling�
These instructions are printed on recycled paper man-
ufactured without chlorine�
English
30
Transportation
of the power tools
Environmental
protection