DWT OF-1050 NV Notice Originale page 27

Symbol
Read all safety regulations
and instructions�
Wear safety goggles�
Wear ear protectors�
Wear a dust mask�
Disconnect the power tool
from the mains before instal-
lation or adjustment�
Movement direction�
Rotation direction�
Locked�
Unlocked�
Double insulation / protec-
tion class�
Attention� Important�
Useful information�
Wear protective gloves�
During operation, remove
the accumulated dust�
Do not dispose of the power
tool in a domestic waste
container�
Meaning
English
27
power tool designation
Power tools are designed for slot and hole milling as
well as for treating the edges of workpieces made from
wood-based materials, plastic, etc�
The use of special accessories also makes it possible
to perform the copy milling, to machine edges of work-
pieces with a curved profile, to mill along the workpiece
edge as well as to mill circular slots (certain accesso-
ries that enable the above listed works to be performed
are not included in the delivery set)�
Power tool
components
1 Lock-on button
2 On / off switch
3 Handle
4 Base plate
5 Wing screw
6 Ventilation slots
7 Controller for the fine adjustment of the milling
depth
8 Locking lever
9 Dust removal cover *
10 Dust removal pipe
11 Spindle lock
12 Collet clamp nut
13 Speed selector thumbwheel
14 Milling depth gauge
15 Indicator
16 Flywheel
17 Locking screw
18 Locknut
19 Adjusting screw
20 Stepped stop
21 Bush *
22 Dust extractor connecting adaptor *
23 Guide bushing fixing screws *
24 Guide bushing *
25 Wrench *
26 Parallel guide (assembly) *
27 Collet
28 Spindle
29 Locking ring
30 Guide *
31 Parallel guide adjusting screw *
32 Fixing screws of the base plate cover
33 Base plate cover
34 Scale
35 Fixing screws of the dust removal cover *
36 Parallel guide fixing elements *
* Optional extra
Not all of the accessories illustrated or described
are included as standard delivery.
Installation and regulation
of power tool elements
Before carrying out any works on the power tool it
must be disconnected from the mains.
Mounting / dismounting / setting-up of
some elements is the same for all power
tool models, in this case specific models
are not indicated in the illustration.
DWT