Xiaomi Mi Vacuum Cleaner Light Manuel D'utilisation page 5

Fixing the Wall Mount
1. Drill two holes with each diameter of 6 mm on the wall at the height of
99.8–101.8 cm above the ground, and ensure there is a distance of 56 mm between
two holes, then insert two wall plugs into the holes.
2. Align the screw holes in the wall mount with the wall plugs, then use two screws
(4×20 mm) to firmly secure the wall mount to the wall.
Note: It is recommended to fix the wall mount near an electrical outlet so that it can
easily connect to the power.
56mm
Align the screw holes
with the wall plugs
Wall Plugs Wall Plugs
99.8-101.8cm
Screw Holes
7
How to Use
Tuning on/off: Press and hold the on/off bu on
cleaner starts working and it runs on the standard mode by default. Press the
on/off bu on again to stop the vacuum cleaner.
Switch mode: When the vacuum
cleaner is running, press the suction
level bu on to switch to the turbo
mode (MAX level); meanwhile, the MAX
indicator will be white. Press the
suction level bu on again to switch to
the standard mode.
Ba ery level indicator: When the
ba ery level is sufficient, the ba ery
level indicator is white. When the
vacuum cleaner runs at a low ba ery
level, the indicator is red; if so, the
vacuum cleaner cannot be switched to
the turbo mode. When the ba ery runs
out, the vacuum cleaner automatically
turns off.
Charging method
1. Before charging, make sure that the
power adapter is well connected to the
electrical outlet and the vacuum cleaner.
2. When charging, the ba ery level
indicator is breathing. Once the ba ery is
fully charged, the ba ery level indicator
goes off.
3. If you charge the vacuum cleaner while
its ba ery is full, the ba ery level indicator
will breath 20 seconds then go off.
MAX Indicator
Ba ery level Indicator
for 1 second, then the vacuum
MAX Indicator
Ba ery level Indicator
Connect to an AC
Electrical Outlet
8