Citizen CT-S801 Type II Mode D'emploi page 44

8. While holdin g down button 1, turn on the pow er.
The function test mode starts and "Self test" appears on the LCD.
9. Press button 3 (
"Calibrate Label" appears on the LCD.
10. Press button 4 (
Paper sensor calibration starts.
11. "Onlin e" will app ear on the LCD if pap er sensor calibration is successful.
If pap er sensor calib ration fails, an error message will appear on the LCD.
To load black ma rk paper
1. Turn off the power.
2. Pull the cover open lever forward and open the pap er cover.
3. Slid e the paper damp er stopp er in the direct ion ind icated by arrow A and release the
paper damp er lock.
Lock the paper damp er whenever you are using black mark la bel paper.
4. Load the paper roll so that th e printab le side of the pape r is facing down.
5. Check to make sure the paper is abo ve the paper d amper.
6. Adjust the paper position so no black mark is located under the black mark sensor.
Paper damper stopper
7. Close the pap er cover.
8. While holdin g down button 1, turn on the pow er.
The function test mode starts and "Self test" appears on the LCD.
Calle Llanos de Jerez 18 Nave 9 Coslada https://v10consumibles.com Tel: 910 269 309
) five times.
).
Paper damper
V10 CONSUMIBLES S.L.
Black mark
Roll paper
Black mark sensor
Black mark sensor
— 40 —
Label guide