Campingaz SUN FORCE ADVANTAGE Mode D'emploi page 10

- Remove the damaged mantle and brush away any
debris, then proceed as described under "Installing the
mantle" and "Burning the mantle".
6 -1. Lighting the lantern using the electronic ignition
- If the heater burner is not operating, open the gas supply
(cylinder valve or regulator lever).
- Switch the gas on by turning the control knob (20) anticlock-
wise, by about 1/4 turn.
- Press the ignition button (B) until the lantern lights, then
release the button.
- If several attempts are unsuccessful, check that the cylinder
contains some gas.
GB
6-2. Lighting the lantern manually
- Apply a burning match or cigarette lighter (C) to the gap
between the glass and the cap, then gradually increase the
gas supply by turning the control knob (20) anticlockwise.
6-3. Adjusting of the brightness
- The brightness of the lantern can be adjusted by slowly turn-
ing the control knob (20).
6-4. Extinguishing the lantern
- Close the valve by turning the knob (20) fully clockwise (
position).
7. Replacing the globe (models with lantern only)
ENSURE THAT THE PATIO HEATER IS COOL AND
SWITCHED OFF.
- Remove the cap (19) from the top of the globe (18).
- Remove the broken globe taking care not to injure yourself
with the sharp fragments
- Install the new globe and clip the cap on top (fig. 17).
8. Replacing the mantle (models with lantern only)
See the "Installing the mantle" paragraph.
9. Moving the equipment (Sun Force Advantage
Deluxe / Sun Force Advantage Comfort)
Never move the equipment whilst in service for safety
reasons.
- Shut down the equipment as indicated in paragraph 3-2-4
and 3-6-4 (models with lantern only)
- Close the gas inlet (cylinder valve (fig. 13A) and/or regulator
lever (figure 13B)).
- Check that the safety strap is holding the gas cylinder firmly
in its housing.
- Tilt the equipment backwards until supported by the wheels
and move it slowly. (fig. 25)
10. Maintenance
10-1. Inspection of the flexible hose between the valves
and the heater burner
- Once per year, check the condition of the hose (which has no
date limit). To do this:
4 disconnect the regulator from the cylinder,
4 remove the control knobs (20) and (21),
4 position the reflector vertically,
4 unscrew the 5 screws (25) - fig. 22 - and remove the flange,
In case of continued difficulty, please contact your local retailer who will give you details of the nearest After Sales
Service point, or call the CAMPINGAZ Customer Service at:
COLEMAN UK PLC - Gordano Gate Wyndham Way - Portishead - BRISTOL BS20 7GG - ENGLAND
WARNING: Due to our policy of continual product development, the company reserves the right to alter or modify this product with-
out prior notice.
4 the flexible hose appears (26) (fig. 23).
- Check that the flexible hose is free from any signs of perish-
ing, such as cracking, cuts or burns.
- If the hose has any defects, return the patio heater to your
supplier.
WARNING: DO NOT ATTEMPT TO REPLACE THIS HOSE
YOURSELF
- If there are no defects, reinstall the flange and secure it with
the 5 screws (25).
10-2. Flexible hose between the regulator and the head of
- Check the state of the flexible hose once a month and repla-
ce it if it shows signs of ageing or surface cracks.
- Replace the flexible hose with a new hose of the same length
and equivalent quality.
- The flexible hose (whether pre-fitted with endpieces or not)
should be replaced according to the timescale indicated
above depending on the country.
- Perform the leak tests in accordance with § 4.
11. Storage and operating anomalies
( ) Only store the patio heater when it has completely cooled:
- Check that the gas supply is properly shut off at the gas cylin-
der (cylinder valve or regulator lever in the closed position).
IMPORTANT: Store the patio heater and its gas cylinder in a
cool, dry and well ventilated place. DANGER: always store out
of reach of children, never in a basement or a cellar. Propane
gas cylinders must be stored outside, in a well ventilated area,
away from inhabited buildings and their outbuildings.
- For extended storage of the patio heater:
4 remove the cylinder from the patio heater,
4 place the reflector in the vertical position and protect it with
a cover, to prevent spiders from entering the venturis of the
burners (spider webs create long flames at the burner).
- In the event of jets becoming blocked (the cylinder still con-
tains gas but the patio heater will not light) do not attempt to
unblock them, return the patio heater to your supplier.
12. Guarantee conditions
The product is covered by a total parts and labour warranty for
2 years with effect from the purchase date, excluding return
transport charges that should be borne by the consumer. The
warranty applies when the delivered product does not conform
to the order or is defective, from the moment that the claim is
accompanied by proof of purchase date (e.g. invoice, till
receipt). The product should be returned carriage paid, com-
plete and assembled, to an authorised after-sales service cen-
tre, with the claim describing the nature of the problem. A pro-
duct for which a claim is being made may be repaired, replaced
or reimbursed, in full or partially. The warranty is null and void
and does not apply if the damage is caused by (i) incorrect pro-
duct use or storage, (ii) defective product maintenance or main-
tenance that fails to comply with the instructions for use, (iii)
repair, modification or servicing of the product by unauthorised
third parties, (iv) the use of non-original spare parts.
NOTE: the professional use of this product is not covered by
this warranty.
CONSUMER SERVICE
Tel: 01275 845 024 - Fax: 01275 849 255
Web site: www.campingaz.com
10
the patio heater