Measuring Without The Temperature Probe; Automa C Temperature Correc On (Atc) - Exotek Instruments MC-410 Manuel Utilisateur

Masquer les pouces Voir aussi pour MC-410:
Table des Matières

Publicité

4.
Push the needle pins or the heavy duty moisture probe
pins into the wood and observe the reading.
5.
Readout the moisture content in %H2O.
6.
Turn off the unit by pressing the "
three seconds.
7.
If the unit is not used it will shut down automa cally a er
one minute if not changed.

15. Measuring without the Temperature Probe

The instrument is calibrated for wood at 20°C (68°F). In general,
mber that is ho er than 20°C will give lower readings and mber
colder than 20°C will give higher readings. An approximate manual
correc on of 0.5% moisture content per 5°C may be subtracted
from mber that is above 20°C. For mber that is below 20°C,
a manual correc on of 0.5% moisture content per 5°C may be
added to the measured value.

16. Automa c Temperature Correc on (ATC)

Switch the instrument on and select the appropriate wood
calibra on scale as detailed in sec ons 14. Drill a hole of nominal
3 mm diameter and push the Temperature Probe into the hole
un l the p is at the required depth. Connect the Temperature
Probe into the instrument via the "Temp" socket. Then using
this instrument to measure mber can obtain the automa cally
temperature corrected (ATC) moisture value. If you need to
reading current temperature of mber press "T" bu on, then LCD
will display the temperature. Press "T" bu on the LCD will display
the other °C or °F temperature. Pressing "
display moisture value again. (Temperature Range: -35°C ~ 80°C).
- 21 -
" bu on for at least
" bu on the LCD

Publicité

Table des Matières
loading

Table des Matières