MTD Cub Cadet 769-25743 Mode D'emploi page 21

Meaning of the symbols
¾ When working always ensure you are stand-
ing safely, especially when using steps or a
ladder .
¾ Always be aware of your environment and
possible hazards which you may not be able
to hear because of the noise of the device .
Information about vibrations:
¾ Vibrations can cause nerve damage and
impair the blood circulation in the hands and
arms .
¾ When working in the cold, wear warm clothing
and keep your hands warm and dry .
¾ Take breaks .
¾ If you notice that the skin of your fingers
or hands goes numb, tingles, hurts or goes
white, stop working with the machine and, if
necessary, consult a doctor .
¾ The specified vibration emission values:
• Were measured according to a standardised
testing procedure.
• Make it possible to estimate the power tool
emissions and compare these with different
power tools. Dependent on the conditions of
use, the state of the power tool or tools inserted
for use with it, the actual vibration load may be
higher or lower. When estimating the emis-
sions, consider doing so during work pauses
and phases when the tool is under reduced
load. Based on the correspondingly adjusted
estimated values, take protective actions, e.g.
organisational actions.
After use
¾ Switch the device off, remove the power pack
and check the device for damage . Attention,
danger! Cutting tool continues running!
¾ If you need to clean or service the device,
switch it off and remove the power pack.
¾ Always wait until the cutting tool comes to a
standstill .
¾ Removal of the protective equipment must
only be performed with the motor stationary
and the power pack removed .
¾ Ensure that ventilation slots are free from dirt .
¾ Do not clean the hedge trimmer using water .
Safety information
General safety instructions
¾ Spare parts must meet the requirements of
the manufacturer . Therefore, use only original
spare parts or those spare parts authorised by
the manufacturer. When replacing spare parts,
always observe the supplied fitting instructions.
Remove the power pack beforehand.
¾ Repairs must only be performed by a quali-
fied expert or workshop. Specialist workshop
addresses can be found on our website.
¾ This hedge trimmer is intended for the care
of hedges in private households . The device
must not be used for purposes other than those
intended because of the risk of bodily injury to the
user or other persons.
¾ Only use the power packs intended for this
purpose in power tools . Use of other power
packs can result in injuries and fires.
¾ Even if all safety and operating instructions
are heeded, there is always a residual risk of
injury and property damage . Always be con-
scious of this!
¾ Do not use the device if it is raining or if there
is a risk of storms .
¾ Replace all worn or damaged information
signs on the device .
¾ Only use power packs and chargers approved
by the manufacturer . The designations of the
approved power packs / chargers are listed in the
enclosed CE Declaration of Conformity.
EN
21