Troubleshooting; Warranty; Ce Declaration Of Conformity; Environmentally-Friendly Disposal - MTD Cub Cadet 769-25743 Mode D'emploi

Troubleshooting

Risk of injuries or material damage
¾ In case of doubt always take your device to a specialist workshop.
¾ Before any inspection or any work on the device, switch off the motor and remove the power
pack.
Problem Possible cause
The device switch- The power pack is too hot.
es off.
The power pack is discharged.
The temperature of the device (electronics) is too
high.
Overcurrent release
The device will not The power pack is discharged.
switch on.
Overvoltage release
Overcurrent release
Power pack temperature too high or too low.
The power pack is defective.
The cutting blade The cutting blade is blunt.
becomes hot.
There is a lot of friction because of a lack of
lubrication.
Uneven running, The cutting blade is damaged.
severe vibration of
The cutting blade fastening has come loose.
the hedge trimmer.

Warranty

The warranty conditions of our local company or
importer apply in all countries. Under the terms of
the warranty we will repair faults on your device
free of charge, insofar as material or manufactu-
ring defects are the cause. To make a claim under
warranty please contact your seller or your nearest
branch.

CE Declaration of Conformity

Further details about the device are con‑
tained on the separately enclosed CE Decla‑
ration of Conformity, which forms part of this
instruction manual.
Troubleshooting
WARNING!

Environmentally-friendly disposal

Power tools, accessories and packaging must be
disposed of via an environmentally compatible recy-
cling chain.
Power packs/batteries:
Do not dispose of power packs/batteries
in domestic waste, by burning or throwing
into water. Power packs/batteries must be
collected, recycled or disposed of in an
environmentally-friendly manner.
Power tools (without power packs/batteries):
Do not throw your old power tool away with the
domestic waste. Take it to a disposal facility.
Remedy
Allow the power pack to cool.
Charge the power pack.
Allow the device to cool and if necessary,
clean the ventilation slots
If this occurs again take your device to a
specialist workshop.
Charge the power pack.
If this occurs again take your device to a
specialist workshop.
If this occurs again take your device to a
specialist workshop.
Allow the power pack to cool down or
heat up.
Replace the power pack.
Consult a specialist workshop.
Oil the cutting blade.
Consult a specialist workshop.
Consult a specialist workshop.
EN
25