Sangean PR-D18 Mode D'emploi page 12

Software version / Setting up the tuning step
increment / 24 / 12 time format
Software version
The software display cannot be altered and is just for your
reference.
. Make sure your radio is in power off mode.
2. Press and hold the Band/step button until the software version is
shown on the display (e.g. P0 X).
Setting up the tuning step increment
3. Continuing pressing and holding the Band / step button until you
hear a beep sound. Now the radio enters FM/AM step setting.
The screen will show FM tuning step (i.e. 50 or 00). Press the
Tuning up / down button to choose between 50KHZ or 00 KHZ
and then press the Band / step button to confirm the selection.
4. After the selection of FM tuning step, the display will show AM
tuning step (i.e. 9 or 0). Press the Tuning up / down to choose
between 9KHZ or 0 KHZ and then press the Band / step button
to confirm your selection.
24/12 time format
5. After the confirmation of AM tuning step, current 12/24 time format
will flash on the display. Press the Tuning up / down button to
selection your requested option. Then press the Band / step button
to confirm your selection.
GB