Federal Signal ESCAPE Serie Instructions D'installation Et D'entretien page 3

Table 1. Wiring for LED Lightbars.
Wire Color Functions
BLACK Not Used
RED Power (+12V)
WHITE Channel #1
BLUE Channel #2
GREEN Channel #3
BROWN Channel #4
III. TESTING.
This product contains high output LED
devices. To prevent permanent eye dam-
age, do not stare into the light beam at
close range.
After installation, check the entire system to ensure
the lights are functioning properly and siren/light
system functions are operating properly.
Table 2. Wiring for Two 9" Remote Lightheads.
Wire Color Functions
WHITE Power (+12V)
BLACK Channel #1
GREEN Channel #2
WARNING
IV. BASIC MAINTENANCE.
High voltages are present inside the
lightbar. Wait at least ten (10) minutes,
after shutting off power, before servicing
this unit. Failure to do so may result in
property damage, serious injury, or death
to you or others.
Disconnect ALL power to the lightbar
before any maintenance is performed.
Crazing (cracking) of domes will cause
reduced effectiveness of light system. Do
not use cleaning agents (which will cause
crazing) such as strong detergents, sol-
vents, or petroleum products. If crazing of
domes does occur, reliability of light for
emergency warning purposes may be
reduced until domes are replaced.
Ordinary cleaning of the plastic domes can be
accomplished by using mild soap and a soft rag. Should
fine scratches or a haze appear on the domes, they can
ordinarily be removed with a non-abrasive, high quality
automotive paste wax.
-2-
WARNING
WARNING