Revell Control Digger 24923 Mode D'emploi page 6

24923
Safety instructions:
• This vehicle is suitable for children
who are at least eight years of age.
Parental supervision is required when
driving the vehicle.
• This vehicle is only suitable for use
indoors.
• After use, remove the batteries from
the vehicle and allow everything to
dry completely! If necessary, apply a
water displacing agent (e.g. WD40 or
similar) to the metal parts in order to
prevent corrosion. Do not expose the
remote control and charging unit to
any moisture!
• Keep your hands, face and loose clo-
thing away from the vehicle during
operation.
• Switch off the remote control and
vehicle when not in use.
• Remove the batteries from the re-
mote control and the vehicle not in
use.
• Always maintain visual contact with
the vehicle in order to avoid losing
control of the vehicle. Inattentive and
careless use can lead to considerable
damage.
• Please keep this operating manual
safe for later use.
• The user may only operate this vehi-
cle in accordance with the instruc-
tions for use in this operating manual.
• Do not drive the vehicle near people,
animals, bodies of water or power
lines.
• This vehicle is not suitable for people
with physical or mental limitations.
• This vehicle may not be used on
public roads!
10
IMporTaNT FeaTureS
Construction Line
• Construction vehicles with
MHz remote controls
• Very authentic design
• Fully functional
• With sound
• In general, it must be ensured that
the vehicle cannot injure anyone in
consideration of potential malfunctions
and defects.
maintenance and care:
• Please only use a clean, damp
cloth to wipe off the vehicle.
• Protect the vehicle and batteries from
direct sunlight and/or direct heat.
• Never allow the remote control and
charging unit to come into contact
with water, because the electronics
will be damaged as a result.
Remote control battery safety
instructions:
• Non­rechargeable batteries
may not be charged.
• Rechargeable batteries must be
removed from the remote control
prior to recharging.
• Rechargeable batteries may only
be charged under the supervision
of an adult.
• Combinations of batteries of different
types or new and used batteries may
not be used.
• Only the recommended batteries
or those of an equivalent type may
be used.
• We recommend alkali manganese
batteries for the remote control.
Single use batteries for this remote
control and other electrical devices
operated in the home can be replaced
with environmentally-friendly
rechargeable batteries.
• Batteries must be inserted with the
correct polarity (+ and -).
• Depleted batteries must be removed
from the remote control.
• The connection terminals may not be
short-circuited. Please remove the
batteries from the remote control if
it will not be used for an extended
period of time.
Charging unit safety instructions:
• Non­rechargeable batteries may not
be charged.
• This charging unit is not suitable for
people (including children) with physi-
cal or mental limitations, or those with
insufficient knowledge and experience
of charging units,
unless under supervision or following
proper directions from a parent or
legal guardian.
• Children must be supervised –
the charging unit is not a toy!
Battery requirement for
the vehicle
Power supply:
Batteries: 4 x 1,5 V "AA" battery
(not supplied)
Battery requirement for
the remote control
Power supply:
Batteries: 1 x 9 V E-Block 6LR61
battery (not supplied)
1 vehICle
1A Bucket sound: AFF - ON
- ON without
1B Lifting mecha-
sound sonido
nism of the arm
1F Screw on the
1C Chain drive
battery com-
1D Battery com-
partment
partment lock
1E OFF/ON switch
for vehicle and
2 reMoTe CoNTrol
2A Left chain 2D Right chain
throttle lever throttle lever
2B Rotation of the 2E Battery
revolving compartment
superstructure
2F ON/OFF switch
2C Control of the
arm and bucket
3 INSerTINg BaTTerIeS
Remote Control
3A Unscrew the screw on the rear side
of the remote control by turning it
anticlockwise and remove the cover.
3B Insert the 9-Volt battery with the
minus pole (large pin) facing
upwards.
3C Then fit the cover in place and close
it again by turning the screw
clockwise.
11