Publicité
Les langues disponibles
Les langues disponibles
Intendend use
The machine is designed for mixing liquid and powder-based building products such as paints, mortar, adhesives, plas-
ter and similar substances. Use the right mixing tool for the consistency of the material and the quantity to be mixed.
Please refer to the information in the technical data when choosing the size of mixing tool (diameter). If you use your
mixer properly and only for what it is intended, you will enjoy years of safe, reliable service.
It is not to be used for the processing or preparation of food or similar products. The machine is not suitable for mixing
of materials containing graphite powder, hydrochloric solutions or liquid manure. Mixing such materials can damage
or destroy the machine.
The user is responsible for damage caused by usage other than intended.
Before using for the first time
Insert the mixing tool with the HEXAFIX mount in the coupling until it locks. To release the mixing tool, simply pull back
the handle-collar on the coupling and this releases the mixing tool.
The guard handle is designed to protect the machine casing from breakage and soiling. In addition, it also makes it
easier to pick up and put down the machine.
Connect the machine to the 110 volt mains power supply. 110 volt devices can also be used with a 120 volt supply.
Be sure your power supply agrees with the nameplate marking. The markings 120 volts 50/60 Hz mean that your
mixer will operate on alternating current. Voltage decrease of more than 10 % will cause loss of power and overheat-
ing. All modells are factory tested; if this tool does not operate, check the power supply.
Operating
WARNING
Always hold the machine with both hands while working.
CAUTION: Befor plugging in the tool, always check to see that the switch trigger actuates prop-
erly and returns to the OFF position when released.
To start first press the starting lockout button (1) than press the ON/OFF switch (2). The
integrated electronic controls will start up the machine in a controlled fashion. The more pressure
you apply to the ON/OFF switch, the faster the machine will run.
To stop working, release the ON/OFF switch.
Machines with 2-speed gear units have two maximum speeds available (First gear: Slow/Second
gear: Fast). To change from one gear to the other, turn the gear selection lever through 180°.
Always reduce the speed when submerging the mixing tool in the mixing material or lifting it
out. Once the mixing tool is fully submerged, increase the speed again to ensure that the motor
is adequately cooled.
During mixing you should guide the machine around the mixing container. Continue mixing until
all of the mixing material is completed mixed.
Clean the mixing tool after you have finished your mixing work.
Accessories: Recommended accessories for use with your tool are available at extra cost from
your local dealer or general distributor.
CAUTION: the use of any other accessory not recommended for use with this tool could be
hazardous.
INFORMATION: Choose the right mixing paddle for every application.
ON/OFF switch
Gear selection lever
Publicité
