Power Stroke PS907000 Manuel D'utilisation page 16

iNSTALLiNG THE FRAME SUPPORT
See Figure 4.
Install the frame support on the bottom of the generator
frame on the same side as the handle.
 Locate the following items:
Frame support
2 flange nuts (5/16-18)
2 washers (5/16 in.)
2 bolts (5/16-18 x 1 in.)
 Raise the end of the generator where the recoil starter is
located high enough to gain access to the frame bottom;
securely position props underneath to support.
 Align the holes on the frame support with the holes on
the generator frame.
 Insert the bolt through the hole in the generator frame so
it extends down through the frame support.
 Slide a washer on the bolt, then install flange nut and
tighten securely.
 Repeat on other side.
iNSTALLiNG THE WHEELS
See Figure 5.
Wheels are provided to assist in moving the generator to
the desired location and should be installed on the side
opposite the handle.
 Locate the following items:
2 bolts (3/8-16 x 5-1/4 in.)
2 washers (3/8 in.)
2 spacers (.38 ID)
2 wheels
2 lock nuts (3/8-16)
 Raise the end of the generator opposite the handle high
enough to gain access to the frame bottom; securely
position props underneath to support.
 Insert a wheel spacer into the center of the wheel.
 Place a washer on the bolt, then slide bolt through the
wheel.
 Slide the bolt through the U-bracket frame on generator.
 Install nut and tighten securely.
 Repeat the process on the other side to install second
wheel.
ASSEMBLy
ATTACHiNG THE HANdLE
See Figure 6.
 Locate the following items:
2 handles
2 bolt (5/16-8 x 3/4 in.)
4 washers (5/16)
2 lock nuts (5/16)
2 handle bracket spacers
 Place handle and spacer on the frame.
 Place a washer on a bolt, then slide bolt through the
handle, the frame and the spacer.
 Slide a washer on the bolt, then install nut and tighten
securely.
 Repeat the process on the other side to install second
handle.
LOCKiNG THE HANdLE
See Figures 7 - 8.
 Locate the following items:
2 handle lock pins
2 lanyards
 Attach the lanyard to the handle lock pin and the handle
as shown in figure 7.
 Extend the handle, then insert the pin through the hole
in the handle and the generator frame to secure handle
in place.
 Repeat the process on the other side to lock the other
handle.
CAUTiON:
Do not attempt to lift the unit by the handle assembly. If
it is necessary to lift the generator, always grasp by the
frame. Use proper lifting techniques to avoid back injury.
RELEASiNG THE HANdLES
 Remove the handle lock pins and lower the handles to
the down position.
WARNiNG:
To reduce the risk of electrocution or explosion, do not
short circuit the battery terminals or charge in a sealed
container. Keep sparks and flame away.
WARNiNG:
Keep metal objects away from the battery terminals.
Metal objects can make a connection from one terminal
to another. Shorting the battery terminals together may
cause sparks, burns, or a fire.
Page 12 — English