GE GTMS855EDMC Mode D'emploi page 5

Power
A
Press to "wake up" the display . If the display is active, press to put the dryer into idle mode .
NOTE: Pressing Power does not disconnect the appliance from the power supply .
Start and Pause
B
Press Start to begin the cycle . NOTE: The door must be closed for the dryer to start the cycle . Pressing Pause will pause the
cycle, the Start will blink and "PAUSE" will scroll across the LCD .
To continue the cycle, press Start again . To stop the cycle, hold the button for 3 seconds .
Display and Status Lights
C
The display shows the approximate time remaining until the end of the cycle .
In addition, this display will, "scroll" the dryer status:
• PAUSE The message "PAUSE" will scroll across the display when the dryer's cycle is paused . The cycle may be
re-started by pressing the Start button .
• door The message "door" will be displayed when the door is opened during the dryer's cycle .
• CyCLE The message "CyCLE" will be displayed when the clothes are dry and the washer is recommending a
preferred cycle for the next load (see CleanSpeak section) .
The message "dELAY" will be displayed when the Delayed Dry is initiated . It will be replaced with the
• dELAY
estimated time when cycle starts .
• ES Dryer in a delay start (4 hour maximum) awaiting lower energy rates (see About Appliance
Communication - Energy Smart section) .
Cycle status lights
Shows whether the washer is in the DRYING, DAMP, or COOL DOWN cycle .
Feature status lights indicate:
The My Settings feature is on for this cycle .
The dryer is locked - will blink once if you press any button or turn the cycle knob .
The signal is on . See the Variable Signal description .
The Energy Smart feature is selected . See About Appliance Communication - Energy Smart section .
The Clean Lint Filter light will stay on for 15 seconds after the cycle stops .
The eDry feature is selected .
A Delay Dry time is set .
GEAppliances.com
5