MaxxGarden 20681 Mode D'emploi page 34

ASSEMBLY INSTRUCTIONS
Leak check
!
WARNING
• Perform all leak tests outdoors.
• Extinguish all open flames.
• NEVER leak test when smoking.
• Do not use the heater until all connections have been leak tested and do not leak.
Hose/regulator
connection
1. Make 2-3 oz. of leak check solution
(one part liquid dishwashing detergent and three parts water).
2. Apply several drops of solution where hose attaches to regulator.
3. Apply several drops of solution wher regulator connects to cylinder.
4. Make sure all patio heater and light valves are OFF.
5. Turn cylinder valve ON.
If bubbles appear at any connection, there is a leak.
1. Turn cylinder valve OFF.
2. If leak is at hose/regulator connection: tighten connection and perform another leak test. If
bubbles continue appearing, the hose should be returned to the place of purchase.
3. If leak is at regulator/cylinder valve connection: disconnect, reconnect, and perform another
leak check. If you continue to see bubbles after several attempts, cylinder valve is defective
and should be returned to cylinder's place of purchase.
If NO bubbles appear at any connection, the connections are secure.
NOTE: Whenever gas connections are loosened or removed, you must perform a complete leak
test.
4. Complete installation.
!
DANGER
• CARBON MONOXIDE HAZARD
• For outdoor use only. Never use inside house, or other unventilated or enclosed areas. This
heater consumew air (oxygen). Do not use in unventilated or enclosed areas to avoid
endangering your life.
Caution: Do not attempt to operate until you have read and understand all General Safety
lnformation in this manual and all assembly is complete and leak checks have been performed.
Before turning Gas supply ON
1. Your heater was designed and approved for outdoor use only. Do NOT use it inside a building,
garage, or any other enclosed area.
2. Make sure surrounding areas are free of combustible materials, gasoline, and other flammable
vapors or liquids.
3. Ensure that there is no obstruction to air ventilation. Be sure all gas connections are tight and
there are no leaks.
4. Be sure the cylinder cover is clear of debris. Be sure any component removed duri'ng assembly
or servicing is replaced and fastened prior to starting.
Before lighting
1. Heater should be thoroughly inspected before each use, and by a qualified service person at
least annually. If relighting a hot heater, always wait at least 5 minutes.
2. lnspect the hose assembly for evidence of excessive abrasion, cuts, or wear: suspected areas
should be leak tested. If the hose leaks, it must be replaced prior to operation. Only use the
replacenment hose assembly specified by manufacturer.
34
Regulator/cylinder
connection