MaxxGarden 20681 Mode D'emploi page 33

PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with pack-
age contents list and hardware contents above. If any part is missing or damaged, do not attempt
to assemble the product. Contact customer service for replacement parts.
Estimated Assembly Time: 60 minutes
Tools Required for Assembly (not included):
Screwdriver with medium blade. Leak detection solution.
STEP 1
1-1. Put the connection straps on the screw holes and then tighten the screws as shown in the
picture.
1-2. Align the cylinder housing with the screw holes of connection straps, then tighten screws with
the screw driver.
Bolt
Washer
Screw
Base
Connection Strap
STEP 2
2-1. As shown in the picture, align the burner with
the screw holes and fix it to the cylinder housing,
then tighten the screws.
2-2. Tighten doublethread on the flame screen and
put one shim on each doublethread.
2-3. Align the fireproof plate with screw holes and
put the fireproof plate on the doublethreads,
then tighten the wing nut.
2-4. Assembly the protective screen mesh and tighten
the nuts.
STEP 3
3-1. Install the wheels as shown in the picture.
3-2. Open the door of the cylinder housing, connect the gas inlet to the regulator using a hose,
tighten them with hoops.
Cylinder Housing
Protective guard
Screw
Wing nut
Reflector panel
Flame screen
Flange nut
Cylinder housing
Washer
Stud
Burner
Screw
33