EZiclean Xpert animal S200 Manuel D'utilisation page 18

Start cleaning
The different cleaning modes:
Auto mode
The robot performs the intended cleaning by automatically adapting to its environment.
- Turn on the main switch, when the light is on, it means that the robot is powered on.
- Then briefly press the button on the robot, the button on the remote control or from the application.
Focus mode
Suitable for floors where dirt is concentrated, the robot cleans the floor «spirally» and intensively.
- Briefly press the button on the robot, the button on the remote control or from the application.
Bordure mode
When cleaning baseboards, the robot cleans along the walls.
- Briefly press the button on the robot, the button on the remote control or from the application.
Manual control
Control the robot manually using the directional arrows.
- Press the directional arrows on the remote control or on the application.
Control of the suction power
Set the suction power according to the different floor types.
- Press the buttons on the remote control or from the application.
Attention: The suction power can only be adjusted in auto mode.
Water flow control
Set the water flow rate.
- Press the button on the remote control or from the application.
Attention: The water flow can only be controlled if the mop is installed on the robot.
Stop cleaning
Stand by
While the unit is running, press the «Start/Pause» button on the robot or the pause button on the remote control or the
app to suspend cleaning.
Start
The robot will go into sleep mode after 10 minutes of inactivity and all lights will turn off.
Use any button on the robot or the app to turn the robot back on.
Stop
Once the unit has stopped working, press the «start» button for a few seconds and all lights will turn off.
If you do not want to use your robot for a long time, set the switch to «O».
If you want to use it regularly, leave the switch on «I» so that it can recharge properly.