Publicité
Les langues disponibles
Les langues disponibles
Connection
1. Connect the telephone cord to a network wall socket and to the
socket on the back of the telephone.
2. Connect the curly cord to the handset and to the socket marked
on the side of the telephone.
3. You will hear a click when the modular plug is correctly in place.
4. Set correct Flash button time to 100 (see Technical Information).
5. Lift the handset and listen for the dial tone.
Ring signal
The ringer volume can be adjusted using
Memories
Saving speed dial numbers
1. Make sure that the
2. Lift the receiver and press
earpiece).
3. Enter the phone number (up to 16 digits) using the keypad. Press
4. Select memory position by pressing the corresponding button.
5. Replace the handset. The number has now been saved.
Remember to return the
position when all the telephone numbers have been saved.
R
Press
if you want a pause in the telephone number.
Wall mounting
The telephone can be wall mounted by using the included wall mount
bracket.
1. Secure two screws, vertically positioned 83 mm apart.
2. The screws should locate into the two keyholes on the back of the
telephone.
3. Remove the hanging peg (located by the hook switch) by pushing it
upwards.
4. Rotate the hanging peg 180 degrees, and then replace it.
English
Settings
/
switch on the base of the telephone is set to
R
P
(
) (ignore anything you hear in the
P
R
/
switch on the base of the telephone to the
R
P
2
.
P
T
q
.
P
(
).
R
Publicité
