Lighting Instruction - Nexgrill 720-0830 Manuel D'instructions

FLAME CHARACTERISTICS
Check for proper burner flame characteristics.
Burner flames should be blue and stable with no yellow
tips, excessive noise, or lifting. If any of these conditions
exist call our customer service line. If the flame is yellow,
this is a indication of insufficient air. If the flame is noisy
and tends to lift away from the burner, this is a indication
of excessive oxygen.
Note: Remove all packaging, including straps, before using the grill
O F F
I GNI T E / HI GH I G NI TE / H IG H
LO W
IGNITE / HIGH
3
IGNITE / ON
25
PDF 文件使用 "pdfFactory Pro" 试用版本创建
Rear Burner
OF F O FF O F F
O FF
IG NI T E / HIG H IG NI T E / HI GH
I GN IT E / O N
L OW LO W LO W
Main Burners
OFF
2
1
LOW
2
1
Grill Lighting Instructions
Visually check the burner flames prior to each
use, The flames should look like this picture, if
they do not, refer to the burner maintenance
part of this manual.
Each burner is adjusted prior to shipment;
however, variations in the local gas supply
may make minor adjustments necessary.
1
Make sure the lid is open.
Push and turn Main Burner knob slowly to
2
IGNITE/HIGH,. Keep knob pressed in until the burner
is lit.
If burner does not light within 5 seconds, turn the knob
3
to OFF and repeat the lighting instruction.
If burner does not light up after step 3, turn the knob to
4
OFF, wait 5 minutes, and repeat the lighting procedure
or light by match.
www.fineprint.cn
continued
Lighting Instructions