Ribiland PRMPP063 Manuel D'instructions page 25

4.4- Starting the engine
Turn the throttle switch in the position of start and set the switch in the state of one second.
1. Open Fuel cock
Fuel cock
ON position
3. Turn the engine switch to the ON
position.
Engine switch ON position
Remarks:
- Hold the engine firmly with your left hand, then pull out the starter handle with your right hand,
gently in the beginning until you feel the resistance, and then pull it out rapidly.
- Please do not pull out all the starting rope and do not release it rapidly to make the rope withdraw
after it was pulled out. Doing so will damage and/or breakdown the starter.
- If you restart the engine after it is stopped, please set the throttle to the "OFF" position.
After the engine is started, turn on the choke throttle gradually and withdraw the throttle switch.
Leave the engine running for 1-2 minutes at low speed to heat the engine.
2. Completely close the choke
Close position
4. Operate the starter grip.
Pull the starter grip rope lightly until you feel
resistance, then pull briskly until engine starts.
Return the starter rope gently.
Repeat operation if necessary, and until engine starts.
- 22 -
Choke lever