Safety; Designated Use En; Responsibilities Of The User En - Abicor Binzel FES-200 Mode D'emploi

2 Safety

2 Safety
The attached safety instructions must be observed.
2.1 Designated use
• The device described in these instructions may be used only for the purpose described in these
instructions in the manner described. In doing so, observe the operating, maintenance and servicing
conditions.
• Any other use is considered contrary to the designated use.
• Unauthorized conversions or power increase modifications are not allowed.
2.2 Responsibilities of the user
Electromagnetic interferences
When used in residential areas.
• Use only in industrial zones according to DIN EN 61000-6-3.
• Any personnel using the fume extraction system or performing maintenance work on the fume extraction
system must be instructed accordingly before use.
This training must include use of the device and the substances for which the device is intended as well
as safe disposal of the absorbed material.
Responsibilities of the user: BetrSichV §7: Observe requirements concerning the condition of the work
equipment. In doing so, observe the following:
• 89/391/EEC: Directive on the introduction of measures to encourage improvements in the safety
• 2009/104/EC: Directive concerning the minimum safety and health requirements for the use of
• 2004/108/EC: Directive on the approximation of the laws of the Member States relating to
• DIN EN 61000-3 part 11: Electromagnetic compatibility, limits - limitation of voltage changes
• DIN EN 61000-6-3: Electromagnetic compatibility - Emission standard for residential, commercial
• DIN EN 61000-6-4: Electromagnetic compatibility - Emission standard for industrial environments
• DIN EN ISO 15012-1: Health and safety in welding and allied processes - Equipment for capture
• Occupational health and safety regulations of the country in question. For example, Germany:
• Regulations on occupational safety and accident prevention
EN - 4
WARNING
and health of workers at work.
work equipment by workers at work.
electromagnetic compatibility.
and light-industrial environments
and separation of welding fume
Occupational Health and Safety Act and Ordinance on Industrial Safety and Health
FES-200