Waring Commercial WWO120 Mode D'emploi page 3

Before you use this product for the first time, please take a
few moments to read these instructions. Keep them for future
reference.
PARTS
1. Battery compartment cover
2. Battery (not shown)
3. Stainless steel housing
4. Power Up/Down switch
5. Power indicator light
6. Charging indicator light
7. Charging base
8. Foil cutter (not pictured)
9. Power adapter
10. Auger (not shown)
11. Replacement auger
12. Auger replacement tool
12
11
9
5
7
1
4
3
8
POWER CHARGE
4
OPERATING INSTRUcTIONS
cONNEcTION AND USE
We recommend that you charge your electric wine bottle opener
for at least ten hours before using for the first time. Please follow
the instructions for recharging as stated below:
REcHARGING YOUR
ElEcTRIc WINE bOTTlE OPENER
Plug one end of the adapter cord into the base of the recharging
base and the other end into an electrical outlet. Place the
electric wine bottle opener into the recharging base, making sure
that it is firmly in position and that it is fully engaged with the
recharging connection. A green charge light will flash indicating
that the unit is charging. It will take approximately 8-10 hours to
recharge your electric wine bottle opener for the first time. When
your electric wine bottle opener is fully recharged, the green light
will stop flashing and become a solid green light. Other charging
times will vary.
Your electric wine bottle opener can open approximately 120
bottles of wine on a full charge.
It is recommended to keep the electric wine bottle opener on the
charging base when not in use to keep a full charge.
FOIl cUTTER
For your convenience, this unit has a
removable foil cutter, which is stored in
the charging base. Before removing the
6
cork, you must remove any foil from the
bottle (see fig 1). Attach foil cutter to the
top of the wine bottle. Keep hand on
lower part of bottle and turn foil cutter in
twisting motion to remove foil. Remove
foil to expose top part of cork surface.
cAUTION: Blade on foil cutter is sharp. Please
keep fingers away from cutter's sharp edges.
TO OPERATE YOUR
ElEcTRIc WINE bOTTlE OPENER
Press and hold the lower part of the switch
(indicated by a down arrow) to remove a cork
(fig 1)
(fig 2)
5