Blumfeldt ASPIRE Mode D'emploi page 27

Operation
1. Plug in the power plug. A beep will sound. The
heater is in standby mode. The ON / OFF button
will light up blue.
2. Press the ON / OFF button. The lamp will light
up white and the device will go into standby
mode. The heating element and the LED are
preset to level 3.
3. Press the heating button or the light button.
The display will flash for 5 seconds. Press the
button again to set the heat level or the light
level. The flashing will stop after 5 seconds and
the setting is complete.
4. If you only want to switch off the heating
element or the light, press the respective button
and then immediately press the on / off button.
5. Finally, put the heater and the lamps into
standby mode by pressing the on / off button.
Remove all transport locks before switching on
the device.
Turn the heating arm
The heating arm can be adjusted horizontally and vertically. Fold up the
heating arm according to the following instructions and fold it down again in
reverse order.
EN
27