Axis Q6055-S Mode D'emploi page 12

AXIS Q6055-S PTZ Dome Network Camera
How to install the camera
NO TICE TICE
NO NO TICE
To comply with the IP66-rated design of the camera and maintain the IP66 protection, the
supplied multicable shall be used.
1. Install the selected bracket according to the instructions supplied with the bracket. If
drilling is required, make sure to use drill bits, screws, and plugs that are appropriate for
the material.
2. Route the multicable through the holes in the mounting bracket.
3. Secure the camera using the supplied safety wire.
1
Safety wire
4. Remove the protection cap covering the multiconnector on the camera.
5. Connect the multicable to the connector on the camera. Use the alignment indicators to
find the correct position.
NO NO TICE NO TICE TICE
Be careful not to damage the multicable when connecting it.
6. Fasten the network camera to the mounting bracket with the screws.
Mounting example (wall bracket sold separately)
12