Cleaning And Maintenance; Transport; Storage - Scheppach GP1300 Jet Traduction Des Instructions D'origine

10. Cleaning and Maintenance

Attention!
Only carry out maintenance, cleaning and
adjustment work when the mains plug is
pulled out.
We recommend that you clean the device
directly after every use.
Clean the device at regular intervals using
a damp cloth and a little soft soap.
Do not use any cleaning products or sol-
vents - they could attack the plastic parts
of the universal machine stand. Make
sure that no water can penetrate the de-
vice interior.
The pump is largely maintenance-free.
However, for a long service life, we rec-
ommend regular checking and care.
Before extended periods of inactivity or
through the winter, the pump should be
thoroughly flushed through with water,
emptied completely and then stored dry.
To empty the pump housing, loosen the
water drain screw (8) and tilt the pump
slightly.
If there is a risk of frost the pump must be
completely emptied.
After longer periods of storage check the
pump by switching on/off briefly in order to
check that the rotor turns normally.
In the event of the pump being jammed
connect the pressure line to the water
supply line and remove the suction hose.
Open the water supply line. Switch the
pump on for ca. two seconds several
times. This method rectifies blockages in
most cases.
To clean the pre-filter (7), unscrew the
pre-filter cap (6) and remove the filter unit.
Clean the pre-filter with warm water.
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
Connections and repairs
Connections and repairs of electrical
equipment may only be carried out by an
electrician.
Please provide the following informa-
tion in the event of any enquiries:
• Type of current for the motor
• Machine data - type plate
• Motor data - type plate
Service information
Please note that the following parts of
this product are subject to normal or nat-
ural wear and that the following parts are
therefore also required for use as con-
sumables.
Wear parts*: Seals, pre-filter
* Not necessarily included in the scope of
delivery!

11. Transport

Use only the transport handle (2) for
transporting the device.

12. Storage

Store the device and its accessories in a
dark, dry and frost-proof place that is in-
accessible to children. The optimum stor-
age temperature is between 5 and 30˚C.
Cover the electrical tool in order to pro-
tect it from dust and moisture.Store the
operating manual with the electrical tool.
GB | 25