Lindab LT 600 Mode D'emploi page 15

10.8 Setup
10.9 Units
10.10 Calibration
• Press the  and  keys to scroll up and down
• Press the  key to select a menu entry
• Press the  and  keys to select a letter or digit to change
• Change the letter or digit by pressing the  and  keys
• To exit, press the  button until you reach the end of the line
If necessary, the functions are dialog-driven
Functions:
• The date/time functions are self-explanatory
• The Brightness option adjusts the screen brightness
• Various options for the units of measurement, explained below
• Setup adjustment allows the PI controller to be customised for auto-
matic measurement, if required Standard values can be selected
• Reset to factory settings
• Mode: use the  key to toggle between user prompt mode and expert
mode
• The  key switches the interface language between German, French,
Swedish and English
• LOGO: you can enter customer-speci c text here, to appear at the top
of the report printout
• Select the units of measurement for the display The device always
bases its internal calculations on the units l/s and Pa
• Select the menu entry by pressing the  and  keys
• Press the  key to select the unit
Available units:
Pressure:
pascal (Pa), hectopascal (hPa), millibar (mBar), water column (mm H
and " )
WC
Leakage fl w rate:
l/s, m³/h, l/min, l/h, CFM, l/s m² (leakage air standardised to 1 m²)
• Exit by pressing OK
• Only accessible by service personnel with a password
O
2
15