Publicité
Les langues disponibles
Les langues disponibles
Operation (Continued)
NEVER turn the water supply off before turning
the engine/motor off. Serious damage could occur to the pump and/or
engine/motor.
NEVER disconnect the high pressure discharge
hose from the machine while the system is
pressurized. To depressurize, turn engine/motor off, turn water supply
off and squeeze gun trigger 2-3 times.
5. After each use, wipe all surfaces of the pressure washer with
a clean, damp cloth.
STORAGE
•
Do not store the pressure washer outdoors.
•
Do not store the pressure washer where it might freeze unless
it has been properly winterized.
Winterizing Instructions
1. Disconnect the high pressure hose from the pump.
2. Insert a 12 inch to 14 inch piece of garden hose into the
pump inlet.
3. Place a funnel in the other end of the garden hose.
Read the manufacturer's instructions for safe
handling and disposal of RV antifreeze.
4. Pour approximately 6 oz. of RV antifreeze into the funnel.
5. Jog the On/Off Switch briefly until the RV antifreeze comes
out of the pump outlet.
6. Disconnect the high pressure hose from the gun and drain
the hose. Hold the gun and lance in a vertical position and
squeeze the trigger to drain the water out.
NOZZLE CLEANING INSTRUCTIONS
A clogged or partially clogged nozzle can cause a significant
reduction of water coming out of the nozzle and cause the unit to
pulsate while spraying.
To clean out the nozzle:
•
Turn off unit.
•
Turn off water supply. Relieve any pressure trapped in the
hose by squeezing trigger 2-3 times.
•
Separate lance from gun.
•
Rotate nozzle to the narrow stream setting. This opens up the
fan blades.
•
Using the included nozzle cleaner, or an un-folded paper clip,
insert wire into the nozzle hole and move back and forth until
debris is dislodged (refer to Figure 13).
•
Remove additional debris by back-flushing water through
the nozzle. To do this, remove the lance from the gun, place
end of a garden hose (with water running) nozzle to nozzle
pushing water and debris out the back opening of the lance.
TIPS FOR EXTENDING THE LIFE OF YOUR PRESSURE WASHER
1. Never operate the unit without water.
2. Your pressure washer is not meant to pump hot water. Never
connect your pressure washer to a hot water supply as it will
significantly reduce the life of the pump.
Nozzle
Figure 13
MAINTENANCE
Observe regular maintenance intervals to ensure maximum
performance and life from the pressure washer. Refer to the
schedule for recommended maintenance. If you operate the
pressure washer in dusty conditions, perform maintenance checks
more often.
MAINTENANCE SCHEDULE
Maintenance Schedule
Daily
TECHNICAL AND CONSUMER INFORMATION
Horizontal Oriented Pressure washer
Pump Detergent Suction
Water to detergent ratio
Water Supply Requirements
Minimum inlet pressure
Maximum inlet pressure
Maximum inlet temperature
Minimum inlet flow rate
Inlet garden hose size
Maximum inlet garden hose length
9
Models:PW135002
Nozzle Cleaner
Action needed
Check water inlet screen and filter.
10 to 1 (10% detergent)
20 psi
100 psi
100˚ F
5 gpm
5/8 in. I.D.
50 ft
www.campbellhausfeld.com
Publicité
