Assembly Instructions - Uberhaus 780-0001B Guide De L'utilisateur

ASSEMBLY INSTRUCTIONS

1.Bottom Panel and tank bolt Assembly
1. Assemble wheels. Take wheel axle (39) through hole of left cart leg (34), put wheel axle sleeve (42) on
both ends (wheel axle sleeve is used to adjust the gap). Then put both ends in wheel (38) (note: follow
direction as shown), then assemble with M8 self-locking nut at each end. Then put on the wheel covers
(37), and make sure that four pins of wheel cover align to four holes in wheel
2. Assemble bottom panel (2). Take 2pcs M6*40 Phillips screws with washers, put them through two left holes
of left cart leg (34), align with holes of bottom panel and tighten. Use 2pcs M6*40 Phillips screws and washers,
insert in two right holes of right cart leg (4) and align with bottom panel. Use 2pcs M6*15 Phillips screws with
washers and insert in two holes of back panel (28), align with holes in left leg & and right leg. Tighten securely.
(note: keep φ 3.2 mm holes of "bottom panel" upwards)
8
Fig. 1
Fig. 2