Uberhaus 780-0001B Guide De L'utilisateur page 21

LIGHTING INSTRUCTIONS
Before Lighting
Inspect the gas supply hose prior to turning on the gas. If there is evidence of cuts, wear, or abrasion, it
must be replaced prior to use.
Screw the regulator (type QCC1) onto the cylinder, and leak check the hose and regulator connections
before operating the grill (see "Leak Testing" instructions on page 21).
Only the pressure regulator and hose assembly supplied with the unit should be used. Never substitute
regulators. If a replacement is necessary, contact customer service for proper replacement.
WARNING
Do not use the grill if the odour of gas is present. Contact customer service at 1-866-206-0888.
TO LIGHT THE MAIN BURNERS
1. Open lid during lighting.
2. Make sure all the knobs are in the "OFF" position, and then turn the propane cylinder valve "ON" by
slowly turning counterclockwise.
3. Push and turn main burner control knob to IGNITE/HIGH, at the same time, press and hold electronic
ignition button to light the burner.
4. Once the burner is lit, release the electronic ignition button and knob.
5. If ignition does not occur in 5 seconds, turn the knob OFF, wait 5 minutes and repeat the lighting
procedure or light by match (see below)
TO MATCH LIGHT THE GRILL
If a burner will not light after several attempts using the control knobs, the burners may be lit with a match.
WARNING
When lighting, keep your face and hands as far
away from the grill as possible.
CAUTION
Remove the warming rack when using a match
to light the grill.
Main Burner
1. If you have already attempted to light the main burner with the igniter, allow 5 minutes for any
accumulated gas to dissipate.
2. Insert a match into the lighting rod as shown
Ignite the match and insert through the cooking grids to the burner.
3. If the burner does not light within seconds turn the knob to the "OFF" position, wait 5 minutes and try
again.
CAUTION
When using a match to light the grill make sure to
use the attached lighting rod.
21
Fig. 25