Publicité
PROBLEMS WITH YOUR APPLIANCE?
Depending on model:
PROBLEMS
The charger becomes hot
The charger is connected but your
appliance is not charging
Your appliance stops during operation
and the charge light(s) ash(es) very
quickly
The charge light ashes and the
appliance stops
The power-brush is not working
properly or makes a noise
The power-brush stops during use of the
vacuum cleaner
Your vacuum cleaner suction is not
working properly or is making a
whistling noise
When the vacuum cleaner is charged,
the charge light(s) ash(es) red or very
quickly.
The red LED on the product ashes
during use
Please keep this user manual.
POSSIBLE CAUSES
The charger is not properly connected
to the appliance or is faulty.
Your appliance may be overheating.
The appliance has lost its charge.
The rotating brush or hose is
obstructed.
The brush is worn.
The belt is worn.
The heat safety device has come on.
The tube or hose is partially blocked.
The dust collector is full.
The dust collector is not properly tted.
The suction head is dirty.
The motor protection lter is full.
The correct charger is not being used
or the charger is faulty.
The suction head brush is blocked.
The battery temperature is too high.
The tube and/or suction head
connectors are dirty or damaged.
The suction motor is not working.
SOLUTIONS
This is perfectly normal. The vacuum
cleaner can remain permanently
connected to the charger without any
risk.
Check that the charger is properly
connected or contact an Approved
Service Centre to change the charger.
Stop the appliance and leave it to cool
down for at least 1 hour.
Recharge the vacuum cleaner.
Stop the vacuum cleaner and clean
them.
Contact an Approved Service Centre to
change the brush.
Contact an Approved Service Centre to
change the belt.
Stop the vacuum cleaner. Check that
nothing is obstructing the rotation of
the brush; if there is an obstruction,
remove it and clean the power-brush,
then turn on the vacuum cleaner.
Unblock them.
Empty it and clean it.
Re-position it correctly.
Remove the power-brush and clean it.
Clean it.
Contact an Approved Service Centre to
change the charger.
Stop vacuuming and check that there
is nothing blocking the rotation of the
brush.
Leave the product to rest for 30 minutes.
If the problem persists, replace the
battery.
Clean the tube and suction head
connectors with a cloth.
Contact an Approved Service Centre to
have your appliance repaired.
EN
9
Publicité
