Switching On And Off; Trimmer Settings - Grizzly Tools ERT 450-20 Traduction De La Notice D'utilisation Originale

GB
Please observe local regulations
concerning noise protection.

Switching ON and OFF

1. Form a loop in the end of the exten-
sion cable, conduct it through the
opening in the upper handle (2) and
hang it on to the strain relief (4).
2. Connect the trimmer to the mains
socket.
3. Ensure a safe stance and hold the
equipment firmly with both hands. Do
not deposit the cutting head on the
ground.
4. To turn on, use your thumb to actuate
the switch lock (3a), then press the
On/Off switch (3b). Release the switch
lock.
To turn off, release the On/Off switch
(3b). There is no continuous operation
mode.
After the trimmer has been
switched off the cutting head will
continue to rotate for a few sec-
onds. Keep hands and feet well
away.
The ON / OFF switch must not
be locked in place. The trimmer
must not be used if the switch
is damaged. There is the im-
mediate danger of injury if the
motor does not switch off after
the ON / OFF switch has been
released.
Caution: Always remove grass
residue from the line cutter so that
the cutting effect is not impaired.
62

Trimmer settings

Adjusting the additional handle:
The additional handle can be set in dif-
ferent positions. Set the handle in such a
manner that the cutting head is slightly tilt-
ing forwards when in the working position.

Release the knurled nut (6) and
adjust the additional handle (5) in
the required position. Retighten the
knurled nut.
Adjusting the height:
The telescopic tube enables you to adjust
the trimmer to your height.
‚
Release the clamp for the handle sec-
tion (8). Adjust the telescopic tube (9)
to the desired length and re-fasten the
clamp (8).
To adjust the cutting angle:
Changing the cutting angle lets you trim
grass at places that are difficult to reach,
e.g. under benches or wall offsets.
‚
Release the clamp for the handle sec-
tion (8). Rotate the handle section (7)
by 90° or 180°. Re-fasten the clamp
(8).
To adjust the handle rod:
The handle rod turns by 90° and 180°
(see chapter: „Working Instructions")
ƒ
Operate the foot lever (10) on the mo-
tor head (11) and tilt the telescopic
tube (9). There are 6 possible posi-
tions.