Removing/Inserting The Battery; Switching On And Off; Setting The Rear Handle; Working With The Hedge Trimmer - Grizzly Tools CH 2000 Li Traduction De La Notice D'utilisation Originale

GB
Reduce the risk of injuries and
accidents by wearing personal
protection equipment and
ensuring that the unit is fully
functional.
Note noise protection and local
specifications.
Removing/inserting the
battery
1. To remove the battery from the device,
press the release button (13) on the
battery (9) and pull the battery out.
2. To insert the battery (9), place it on the
guide track (14) and push it back into
the appliance. It will audibly snap in.
Do not insert the battery until
the appliance is fully assembled.
Risk of injury!

Switching On and Off

Ensure that you are standing in a
firm position with both hands grip-
ping the hedge trimmer away from
the body. Ensure that the trimmer
is in contact with no other objects
before switching on.
Removing the blade guard:
1. Press the blade guard (
points marked
move it.
Turning on:
2. Check that the battery (9) is in (see

"Removing/inserting the battery").

3. Press the safety switch (4) at the front
handle (5).
4. Press the On/Off switch (7). The
hedge trimmer will run at top speed.
64
5. Release the safety switch (4) or the
The rear handle (8) can be placed into
three different positions (-90°, 0° and 90°).
1. Slide the release button (15) back-
2. Rotate the rear handle (8) into the de-
3. Let go of the release button (15). The
Working with the Hedge
Trimmer
•
•

Cutting Techniques

11) at the
and re-
•
•
•
Turning off:
On/Off switch s (7).

Setting the rear handle

wards.
sired position.
rear handle (8) will latch into position.
During cutting work, ensure that no
contact is made with objects, e.g.
such as wire fencing or main plant
stems. This may result in damage
to the cutter bar.
If the blades become jammed with solid
objects, turn the device off immedi-
ately and remove the rechargeable
battery. Only then should you remove
the object.
Avoid overstraining the equipment
during work.
Cut thick branches beforehand using
a branch clippers.
The double-sided cutter bar enables
cutting in both directions or, with a
swinging action, from one side to the
other.
In case of vertical cutting, move the
hedge trimmer uniformly forward or up
and down in an arc movement.