Assembling Instructions; Operation - Grizzly Tools ERT 450-20 Traduction De La Notice D'utilisation Originale

not be moist nor operated in a
moist environment. Water entry
into the equipment increases
the risk of electric shock.
• Avoid body contact with
earthed parts (e.g. metal fenc-
es, metal posts). There is an
increased risk of electric shock
if your body is earthed.
• Only use extension cables with
a maximum length of 75 m
that have been approved for
open-air use. The stranded
cord diameter of the extension
cable must be at least 2.5 mm
Always unreel a cable drum to
its full length so that the entire
cable can be inspected for
damage.
• Never pass an operating equip-
ment over the extension cable.
Ensure that the power cable is
always trailing behind the op-
erator. The extension cable can
be accidentally severed.
• Use the envisaged cable sus-
pensions when attaching an
extension cable.
• Never carry the equipment by
its power cable. Never pull the
cable to disconnect the plug
from the mains socket. Protect
the cable from heat, oil and
sharp edges. The mains power
cable could be damaged.

Assembling instructions

Always disconnect the plug be-
fore working on the trimmer and
wait until the cutting lines have
completely stopped. There is the
danger of electric shock and the
possibility of injury by the cut-
ting lines.
Use OEM parts only and mind
the thread cutter during assem-
bly. Risk of injury!
Assembling the protection
cover:
1. Place the protective cover (12)
on the motor head (11).
2. Fasten the protective cover us-
ing two of the screws provided.
Mounting the distance roller:
3. Place the distance roller (15) on
the motor head (11).
.
2
4. Fasten the distance roller using
two of the screws provided.
Mounting the additional han-
dle:
5. Pull the ends of the additional
handle (5) apart and slide them
over the handle unit (19).
6. Screw on the additional handle.
Mounting the additional
handle:
1. Pull the ends of the auxiliary
handle (5) to extend the handle
and slide it over the handle rod
discs (19).
2. Screw down the auxiliary handle.

Operation

Caution: Risk of injury!
Never use the trimmer without
its protective cover. Always
check the operability of the trim-
mer before it is used. Check that
the mains voltage is the same as
indicated on the rating plate.
Always wear goggles when
working with the trimmer.
GB
61