Eiki LC-X85 Guide De Référence Rapide page 19

Lamp Replacement
When the projection lamp of the projector reaches its end of life, the Lamp replacement icon appears on the
screen and LAMP REPLACE indicator lights orange. Replace the lamp with a new one promptly. The timing
when the LAMP REPLACE indicator should light is depending on the lamp mode.
Top Panel
LAMP REPLACE indicator
Follow these steps to replace the lamp.
Turn off the projector and unplug the AC power cord. Let
1
the projector cool for at least 45 minutes.
Open the filter cover.
2
Loosen the screw and open the lamp cover. Pull out the
3
lamp by using the built in handle.
Replace the lamp with a new one. Make sure that the
4
lamp is properly and fully inserted.
5
Close the lamp cover and secure the screw.
6 Close the filter cover.
7 Connect the AC power cord to the projector and turn on
the projector.
8
Reset the Lamp counter.
See "Resetting the Lamp Counter" in the owner's
manual (CD-ROM).
✔
Note:
• Be sure to insert the lamp in the correct direction.
• Do not reset the Lamp counter when the projection lamp is
not replaced.
ORDER REPLACEMENT LAMP
Replacement lamp can be ordered through your dealer.
When ordering, give the following information to the dealer.
●
Model No. of your projector
LC-X85
●
Replacement Lamp Type No.
POA-LMP124
CAUTION
Allow a projector to cool for at least 45 minutes
before you open the lamp cover. The inside of the
projector can become very hot.
Lamp replacement icon
(Service Parts No. 610 341 1941)
- 19 -
Filter cover
CAUTION
For continued safety, replace with a lamp of the
same type. Do not drop the lamp or touch the
glass bulb! The glass can shatter and may cause
injury.
Lamp cover
Handle
Lamp